The LHG LTE kit is a device for remote locations that are within cellular network coverage
Mount it outdoors, on a pole, mast or any high enough structure, and connect even where cell phones can’t
Due to it’s large sized high gain antenna, the device is capable to connect to cell towers in extreme rural locations, giving you the ability to provide last mile internet access where nothing else is available
The unit is equipped with one Ethernet port, has a built in high quality Category 4 modem for speeds of up to 150 Mbit/s downlink and 50 Mbit/s uplink
RBLHGR&R11e-LTE-US includes LTE modem that supports LTE bands 2, 4, 5 and 12
The LHG XL HP5 is a 5GHz 802.11 a/n wireless device with an integrated dual polarization 27 dBi grid antenna and high TX output power, designed to reach up to 40km in point-to-point setups at full speed.
The grid design ensures protection against wind, and the fact that the antenna element is built into the wireless unit means no loss on cables.
License level3, CPU- AR9344, CPU nominal frequency- 600 MHz, Size of RAM - 64 MB, Storage size - 16 MB, Storage type - FLASH
PoE in - Passive PoE, PoE in input Voltage - -10-28 V, 2 x Wireless 5 GHz number of chains
Antenna gain 27 dBi for 5 GHz, 1 x 10/100 Ethernet ports
RouterBOARD 2011UiAS-2HnD it’s powered by the new Atheros 600MHz 74K MIPS network processor, has 128MB RAM, five Gigabit LAN ports, five Fast Ethernet LAN ports and SFP cage.
RouterBOARD 2011UiAS-2HnD it features 1000mW dual chain 2.4Ghz (2312-2732MHz depending on country regulations) 802.11bgn wireless AP, RJ45 serial port, microUSB port and RouterOS L5 license, as well as desktop case with power supply, two 4dBi Omni antennas and LCD.
The RB260GSP is a small SOHO switch, which features power output on it’s ethernet ports. Ports 2-5 can power other PoE capable devices with the same voltage as applied to the unit (passive PoE over datalines only).
The RB260GSP has five Gigabit Ethernet ports and one SFP cage, switching is done by an Atheros Switch Chip. The device is running an operating system designed specifically for MikroTik Switch products - SwOS.
This S+DA0001 is highly cost-effective way to connect two SFP/SFP+ devices for very short distances, within racks and across adjacent racks.
The RB2011 is a low cost multi port device series. Designed for indoor use, and available in many different cases, with a multitude of options.
RouterBOARD 2011UiAS-RM, in comparison with RB2011L series, not only has five Gigabit LAN ports and five Fast Ethernet LAN ports, but also has RJ45 serial port, USB port and more RAM (128MB instead of 64MB).
Dynamic routing, hotspot, firewall, MPLS, VPN, advanced quality of service, load balancing and bonding, real-time configuration and monitoring - just a few of the vast number of features supported by RouterOS.
There is PoE output function for port #10 - it can power other PoE capable devices with the same voltage as applied to the unit. Maximum load on the port is 500mA.
RouterBOARD 2011UiAS-RM comes with 1U rackmount enclosure, LCD panel and power supply.